Indoor Station; Outdoor Station; Indoor Unit - Me ADF-510 Mode D'emploi

ADF-510 | ENGLISH
DIGITAL WIRELESS DOOR ENTRY PHONE
MOD. ADF 510/501 EX
OPERATING INSTRUCTIONS
Please read these instructions carefully in order to avoid assembly errors
and keep them for possible later use!
1. DEVICE DESCRIPTION
With this door intercom system, you can have a conversation with a
visitor before opening the door. It works according to the push-to-talk
principle, i.e. you hold down the talk button while talking to a visitor
and release the talk button to hear the visitor.

1.1. INDOOR STATION

Handset
1) Loudspeaker
2) Battery-controlled LED (indoor station batteries)
3) Press to talk button
4) Battery-controlled LED (outdoor station batteries)
5) On/off button
5.1) Volume +
GB
5.2) Volume -
Base station
6) Jack for the adaptor
6.1) LED for charging control

1.2. OUTDOOR STATION

7) Loudspeaker
8) Bell push and nameplate
10) Casing screws
11) Microphone
12) Pairing button
13) Rubber covers
14) Power supply connection
2. FUNCTIONS AND TECHNICAL DETAILS
• 2.4 GHz – digital wireless technology
• Very good sound quality
• Safety ensured through AFH function
(Adaptive Frequency Hopping)
• Battery monitoring
• Low power consumption
Specifications of indoor and outdoor stations
Transmission frequency
Transmission performance
Modulation type
Range
Power supply to indoor station
Power supply to outdoor station
Power consumption indoor station
Power consumption outdoor station
Operating temperature
Storage temperature
Specifications of base station
Power supply
Output voltage / power
Maximum charging current
Charging time
Operating temperature
Storage temperature
3. INSTALLATION INSTRUCTIONS
You should try out the system before final mounting in order to test
whether there is sufficient wireless range.

3.1. INDOOR UNIT

Step 1: Remove the base station, the headset and the mains
unit from the packaging.
Step 2: Insert 3 1.2 Volt NiMhType AAA storage batteries into
the battery compartment of the indoor unit
Step 3: Connect the mains unit to the base station by inserting
the plug into the socket on the base station (6).
Step 4: Place the headset on the base station.
Note: If the storage battery is completely empty the charging
process will take approximately 3 hours.
10 10
2.400 ~ 2.454 GHz
+18 dBm
FHSS + GFSK
150 m (open area)
Storage batteries
3x 1.2 Volt Type AAA
Mains unit 8-10 Volt AC/DC
– 3x 1.5 Volt Type C
Standby ≤ 25 mW
In operation ≤ 120 mW
Standby ≤ 1 mW
In operation ≤ 1 W
-20° to +40° C
-40° to +85° C
DC 6V 800 mA
6V 500 mA
500 mA max.
3 hours
0 to +50°C
-40° to +85°C