Publicité
E11
Overloading Protection: Max load exceeded.
Error code will persist for 20 seconds (DO NOT
operate). Take the things off the desk and
confirm there is no mechanical damage before
trying again.
E12
Motor Phase Error Protection: Power off, check
the cable connection between the motor and the
controller, and power back on again. Then follow
the reset instructions. If the error code persists,
please contact technical support.
E13
Sensor Malfunction Warning: Motor sensor can't
be detected. Power off, check the cable
connection between the motor and the controller,
and power back on again. Then follow the reset
instructions. If error code persists, please contact
technical support.
E14
Anti-Collision System Warning: Impact detected.
The desk will move 2" (50mm) in the opposite
direction and stop.
E16
Cable Disconnection Warning: Check motor and
controller cable connections. Normal operation
should return once all connectors are properly
connected. If error code persists, please contact
technical support.
E17
Mechanical Failure Warning: Check if there is
any structural damage or motor fault.
12
FR
1
x1
Pied gauche
3
x1
Plateau de table
5
x2
6
x1
Base du pied
Alimentation électrique
M-8
x8
M-B
x8
Vis M8x 16mm
Vis M6x35mm
2
x1
Pied droit
4
x1
Tige d'entraînement
7
x2
Clip de câble
M-C
x1
Clé
13
Publicité
