Publicité
2
Use the (M-C) wrench again to tighten the 4 (M-A) screws into the
holes shown in the picture.
3
06
First, loosen the two plastic nuts of the drive rod (4), shorten the
drive rod to the shortest length, and then insert the drive rod into the
right leg hole as shown in number ① in the figure. Then, extend the
drive rod and thread it into the left leg hexagonal rod as shown in
number ② in the figure. Finally, lock the two plastic nuts as shown in
numbers ③ and ④ in the figure respectively.
4
Long
Side
Long
Side
As shown in the figure, first place the leg base (5) on the left and
right legs respectively, and make sure that the long side direction of
the leg base and the desktop are consistent; Use a (M-C) wrench to
tighten the 8 (M-B) screws into each of the two leg bases.
Long
Side
Long
Side
07
Publicité
