Publicité
● Reset
Press and hold the
button until 'rst' is displayed. Continue
holding until the desk goes down to its lowest level and comes back
up slightly. Release the button, and reset is complete. If the button is
released during the reset procedure, reset will stop. The desk won't
work until reset is done correctly.
● Child Lock
Press and hold the
and
turn child lock on. The screen will show 'LOC' and the buttons will be
disabled. Turn child lock o the same way.
● Settings Menu
Press and hold the
button for 5 seconds to enter the settings
menu. Short-press the
Short-press the
or
the
or
button to quickly adjust the height settings. Press and
hold the
button again to save the changes. 'SUS' will be
displayed if saving is successful (or 'FAL' if saving fails). If there is no
button-press for 10 seconds, the settings menu will be exited
automatically.
● Power-Saving Mode
The screen will turn off if there is no button-press for a minute. Any
button-press will turn the screen on again.
10
Setting
buttons together for 5 seconds to
button to navigate through the menu.
button to adjust the settings. Long-press
Protection Mode Error Codes
SC0
Standby Overvoltage Protection: Standby
voltage is too high. Power off the desk, check the
connection between power and the controller,
and power on again. If the error code persists,
please contact technical support.
SC1
Power Supply Overvoltage Protection: Input
voltage too high. If the correct AC adapter is
being used, power off the desk, check the
connection between power and the controller,
and power on again. If the error code persists,
please contact technical support.
SC4
Operating Overvoltage Protection: The operating
voltage is too high. Power off the desk, check the
connection between power and the controller,
and power on again. If the error code persists,
please contact technical support.
hot
Overheating Protection: When the motor has
been working continuously for too long, it will
stop operating to prevent overheating. Wait for at
least 18 minutes (until the error code disappears)
before making any further height adjustments.
r-6
Power Supply Overvoltage Protection (during
use): Input voltage too high. Error clears when
power supply voltage returns to normal. If error
code persists, please contact technical support.
rst
Reset Warning: Continue to complete reset.
E10
Short Circuit Protection: Power off, check the
cable connections, and power back on again. If
the error persists, please contact technical
support.
11
Publicité
