Publicité
EN
DESCRIPTION
-
Distributed audio for PA installations with 100 speakers, also with low impedance output.
-
Safe and durable connections with low maintenance.
-
With 3 mic/line inputs and 2 auxiliary inputs.
-
User-friendly operation and a modern, discreet design.
CONTROLS AND FUNCTIONS
FRONT PANEL
1
1.-
: indicator light and on/off switch of the amplifier.
2.- CH 1- PAGING MIC/CH 2/CH 3: volume controls for the CH 1, CH 2 and CH 3 inputs on the rear panel.
3.- MASTER: volume control of the input selected by the INPUT selector switch.
1
4.- INPUT: input source selector: AUX 1 o AUX 2.
5.- SIGNAL: output signal status LED indicator. Lights up when signal is detected at the outputs.
6.- CLIP: output signal peak LED indicator. If it is turned on, you must reduce the volume of the input that
produces it and/or the output. Do not allow this indicator light to remain on continuously.
7.- PROT: protection LED indicator. Lights up when the amplifier protection is activated to prevent
component damage. With protection enabled, the audio output of that channel is cut off. If this happens,
turn off the device, make sure that the air intake and exhaust slots are clear of obstructions, turn
down the volume of the input signal and check that the speakers connected to the output are working
1
properly and are suitable for this output (power and impedance). Wait a few minutes for the appliance
to stabilize before you switch it on again.
REAR PANEL
1
1.- AUX 2/AUX 3: stereo auxiliary inputs for connection of audio devices such as mixers, computers, etc.
These inputs have 2 connector options, 2 x RCA or euroblock.
2.- CH 2/CH 3: audio inputs from dynamic microphone (MIC), condenser microphone (PHANTOM
+48 V) or lines (LINE), balanced eurolock connector. Once the input type has been selected with the
MIC/PHANTOM +48 V/LINE selector, the gain of the input can be adjusted with the GAIN control.
2
3 4
5 6
2
3 4
5 6
2
7
8
9
10
2
7
8
9
10
- 2 -
3
4
5
6 7
14 15
3
4
5
6 7
14 15
Publicité
