Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE
WARNING: A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION.
TO REDUCE THE RISK OF A SPARK NEAR THE BATTERY:
Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a larger diameter than
7.1
NEGATIVE (NEG, N, –) post.
Attach at least a 24-inch-long 6-gauge (AWG) insulated battery cable to NEGATIVE (NEG, N, –) battery post.
7.2
Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery.
7.3
7.4
Position yourself and free end of cable as far away from battery as possible – then connect NEGATIVE
(BLACK) charger clip to free end of cable.
Do not face battery when making final connection.
7.5
When disconnecting charger, always do so in reverse sequence of connecting procedure and break first
7.6
connection while as far away from battery as practical.
A marine (boat) battery must be removed and charged on shore. To charge it on board requires
7.7
equipment specially designed for marine use.
8.
GROUNDING AND AC POWER CORD CONNECTIONS
This battery charger is for use on a nominal 120 volt circuit. The plug must be plugged into an outlet that
8.1
is properly installed and grounded in accordance with all local codes and ordinances. The plug pins must
fit the receptacle (outlet). Do not use with an ungrounded system.
DANGER: Never alter the AC cord or plug provided – if it does not fit the outlet, have a proper
8.2
grounded outlet installed by a qualified electrician. An improper connection can result in a risk of an
electric shock or electrocution.
USING AN EXTENSION CORD
8.3
The use of an extension cord is not recommended. If you must use an extension cord, follow these guidelines:
• Pins on plug of extension cord must be the same number, size, and shape as those of plug on charger.
• Ensure that the extension cord is properly wired and in good electrical condition.
• Wire size must be large enough for the AC ampere rating of charger, as specified:
Recommended minimum AWG size for an extension cord
AC input rating, amperes*
At least
0
2
3
4
5
6
8
10
12
14
16
18
*If the input rating of a charger is given in watts, rather than in amperes, the corresponding ampere rating is
determined by dividing the wattage rating by the voltage rating, for example: 1200 watts/120 volts=10 amperes.
But less than
25 (7.6)
2
3
4
5
6
8
10
12
14
16
18
20
Length of cord, feet (m) / AWG size of cord
50 (15.2)
18
18
18
18
18
18
18
18
18
16
18
16
18
14
16
14
16
12
16
12
14
12
14
12
• 5 •
100 (30.5)
150 (45.6)
18
16
16
14
16
14
14
12
14
12
12
10
12
10
10
8
10
8
10
8
8
8
8
6
ENGLISH
Publicité
Table des Matières
