Publicité
Positioning the Peg Board
Do not hang any objects on the peg
CAUTION
board without securing the board
in place.
The peg board is shipped and secured in its stored
location. Remove bolts and connecting brackets from
pegboard. With the help of another person, carefully
lift the pegboard up into the upright position. Position
a pegboard bracket over the holes on the pegboard
and secure to the cabinet using six bolts (AA). Repeat
this process for the other side of the pegboard to
attach it to the cabinet.
Attaching the Side Handle
Attach the side handle to the station using four bolts
(AA). The side handle can be attached to either side
of the station.
NOTE: The holes in the station are tapped and do
not require nuts.
Installing the Bumpers
Attach the bumpers to the cabinet using two screws
(CC) per bumper.
Installing the Cord Storage Brackets
Attach the brackets to the station with two screws
(BB) per bracket. Orient the brackets with one pointed
up and one pointed down so that the power outlet
cord can be wrapped around the brackets for storage.
Attach the tool hanger to the left end of the station
using two bolts (AA).
Attach the shelf hinge brackets to the right cabinet
using two bolts (AA) for each bracket. Attach the
storage shelf to the brackets using one washer (FF),
nut (DD) and bolt (EE) on each end.
AA
Reversing the Wood Work Surface
The wood work surface comes pre-installed with
the station. After wear and tear, the surface may be
reversed to use the clean bottom surface. To reverse,
remove the six screws from the top of the wood work
surface, flip surface, and reinstall the six screws.
Attach the bottle opener to the left side of the cabinet
using two screws (GG).
The USB ports on the power outlet can be used to
charge any device that uses less than 2.1A of DC
electrical current.
NOTE: Any device that uses more than 2.1A of DC
electrical current will trip a self-resetting overload and
disable the output.
Place the drawer liners in appropriately sized drawers
to protect the surface.
5
Attaching the Tool Hanger
Installing the Storage Shelf
FF
Installing the Bottle Opener
USB Power Outlet
Installing the Drawer Liners
CC
DD
AA
EE
Publicité
