Publicité
BASE GENERAL VIEW
As shown in Fig. 5.
6, 7, 8 and 9 – Temperature selection button; 10 - Insulation button; 11 - Heating / Stop
button;
USE METHOD:
1.
For burning the water, Select the cover shown in Figure 1. If cooking the tea, you can
directly remove the lid (shown in Fig. 6) to place the tea into the tea bag and then add
the appropriate water to the level between MIN and MAX shown by the kettle water
gauge.
2.
After adding water, place the lid properly; lift up the tea bag (Fig. 8) after covering the
lid and then place the kettle on the base; insert the power plug into the corresponding
power socket and then the buzzer will beep twice and all indicators is on for one
second, so the kettle is at the standby state if no any other operation.
3.
The corresponding indicator will be on if the heating temperature is set, so the heating
will start if the
twice and the temperature indicator will be on if up to the setting temperature, so the
kettle is at the standby state if no any other operation for one minute.
4.
Press the insulation button twice to start and press it again to cancel. Only the 70℃,
80℃, and 90℃ can be selected for insulation rather than 100℃. If the insulation
function has been selected, this function will be canceled if the temperature is set to
100°C.
In case of the insulation function selected, if the heating button can not be pressed within
one minute, the insulation function will be canceled to enter into the standby mode.
In case of the insulation function selected, if the heating button is pressed within one
minute, the insulation timing of 30 minutes will count down.
Fig. 4
heating button presses. The indicator will flash, the buzzer will beep
Fig. 5
Publicité
