Publicité
No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
Before storing your vacuum the tank should be emptied and cleaned. Never allow liquids to sit in the tank
for any extended period of time. The vacuum should be stored indoors.
Do not attempt to service your Shop-Vac
Refer all other servicing to a qualified service center.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES
Parts/accessories
1. Packed in tank
missing
Vacuum cleaner
1. No power at receptacle
will not start
2. Defective switch
3. Defective motor
Dust discharging
1. Filter not installed/not installed
from exhaust
properly
2. Filter damaged
3. Filter clogged or dust is too fine
4. Filter not functional
Loss of suction
1. Loose hose connection
2. Filter clogged
3. Full tank
4. Hole in hose
Static shock
1. Dry environment
2. Relative humidity of air is low
WARNING
–
DETACHED OR BROKEN, EXPOSING THE MOTOR OR ANY OTHER ELECTRICAL COMPONENTS,
OPERATION SHOULD BE DISCONTINUED IMMEDIATELY TO AVOID PERSONAL INJURY OR
FURTHER DAMAGE TO THE VACUUM. REPAIRS SHOULD BE MADE BEFORE REUSING THE
VACUUM.
LUBRICATION
STORAGE
SERVICE
wet/dry vacuum cleaner beyond that described in this manual.
®
IF ANY OF THE MOTOR HOUSING PARTS SHOULD BECOME
SOLUTION
1. Check in tank
1. Check for power
2. Contact Shop-Vac
®
customer service
3. Contact Shop-Vac
®
customer service
1. Properly install filter
2. Replace filter
3. Use more efficient filter
4. Clean or replace filter
1. Tighten hose connection
2. Clean or replace filter
3. Empty tank
4. Replace hose
1. Add moisture to air (if
practical, use a console
or installed humidifier).
2. This situation is temporary
and does not affect the use
of the vacuum cleaner.
PAGE 13
Publicité
