Publicité
3. Adjustement of the head ring
Almost all ABUS helmets are available in 2 sizes.
Adjusting the helmet to the individual head size
can be achieved, depending on the type, with the
following easy to use fitting systems.
4. Adjustment of the straps
When wearing the helmet for the first time, please adjust the straps so that they meet
tautly and comfortably beneath the ears.
The easily adjustable triangular locks (fig. 1 + 2) on both sides, with their optional fastener
(fig. 1) help you in doing so.
The child proof lock must be engaged properly, before first use, with an audible "click" to
prevent accidental displacement.
Make sure the chin-guard, which must be locked before every ride, doesn't lie on the
jaw-bone (fig. 3 – 5).
After adjustment, the overlapping straps can be secured with the strap clip (fig. 6).
Should the straps be too long, please cut them down to the required length and seal the
ends with a match flame to prevent fraying.
5. Proper maintenance and care
• Regularly check the helmet for signs of damage.
• Do not alter the specification of this helmet as it will reduce its protective effect.
• Do not apply stickers or paint to the helmet as this can be damaging to the materials.
• Do not remodel or misuse the helmet.
• Do not expose the helmet to temperatures in excess of 60˚C. Do not store behind glass,
e.g. in a car (burning glass effect), near heaters etc.
• If you suspect that the helmet has received a large impact, even if there is no visible
damage, please purchase a new helmet.
• This helmet has a limited service life and should be replaced when it shows obvious
signs of wear.
• Depending on the frequency of use and the specific operational conditions, a bicycle
helmet must be replaced 4 - 5 years after the first time it is used. In view of the unavoi-
dable material fatigue, the helmet must, however, be replaced at most 8 years after its
production date even if it displays no clear visible or technical defects
• The helmet, inner pads and head ring can be cleaned using lukewarm water,
solvent-free detergents and a soft cloth.
• The LED rear light does not replace the statutory lighting installation requirement
for bicycles.
• Only use original spare parts.
5
ABUS_Helmets_Smiley-3.0_BDA_148x105mm_MMO.indd 5-6
ABUS_Helmets_Smiley-3.0_BDA_148x105mm_MMO.indd 5-6
Battery instructions
• Do not use or store the product in areas where the temperature could reach below 0°C or
above +60°C. Do not expose the product to direct sunlight for long periods of time.
Smiley 3.0 LED:
• Keep batteries out of the reach of children. Children may put batteries in their mouths
and swallow them. This can cause serious harm to their health. Seek immediate medical
attention in this event!
• Risk of burns from contact with leaking or damaged batteries! In these cases, use
suitable protective gloves and clean the battery compartment with a dry cloth.
• Batteries must not be dismantled, punctured, damaged, short-circuited, heated,
charged or thrown into an open fire (risk of explosion!).
Smiley 3.0 ACE LED:
• This product contains a built-in 3,7 V lithium polymer battery (40mAh). Built-in
rechargeable batteries may only be replaced or removed by qualified personnel. Do not
charge or use the product in environments where there is a risk of explosion, e.g. from
flammable liquids, gases or dust. Never burn the product! The battery could explode in
the fire. This would also release toxic substances.
• Only use a suitable standard micro USB B charging cable in conjunction with a suitable
charger (5V DC power supply unit) for charging!
• Do not leave the product unattended while it is charging!
Disposal
This product contains valuable raw materials. At the end of its service life, dispose of the
product in accordance with the applicable legal requirements.
Electrical appliances, rechargeable batteries and batteries must not be disposed of with
household waste. Disposal must be carried out in accordance with Directive 2012/19/EU on
waste electrical and electronic equipment (WEEE), or Directive 2006/66/EC on batteries and
accumulators and waste batteries and accumulators.
Please contact the local authority responsible for disposal if you have any queries. You can
obtain information on collection points for your old appliances, for example, from the local
municipal or city administration, the local waste disposal companies, or your specialist
dealer.
Dispose of the packaging according to type. Separate the cardboard, foil and plastic ele-
ments for recycling.
WEEE-Reg.-Nr. DE79663011
6
14.04.2022 12:12:46
14.04.2022 12:12:46
Publicité
