GE GTE18N Manuel D'utilisation Et Instructions D'installation page 20

Accessory
Icemaker Accessory Kit IM4D
cost. Check the back of the refrigerator for the specific
icemaker kit needed for your model.
To order, call GE Appliances at 800.GECARES
(800.432.2737) or visit GEAppliances.com. In Canada,
visit GEAppliances.ca or call 800.561.3344.
About the IM4D Icemaker
CAUTION
To prevent the risk of injury or burn, do not place fingers or hands in or around the automatic
icemaking mechanism while the refrigerator is running.
The icemaker will produce seven cubes per cycle—
approximately 70-100 cubes in a 24-hour period,
temperature, number of door openings and other use
conditions.
Owner's Manual that comes with the kit.
Icemaker and Water Valve Installation
Remove the icemaker plug
cover on the ceiling of the
the instruction in the icemaker
owner's manual from the kit to
install the icemaker and water valve.
place ice bucket on the shelf under the icemaker.
Be sure the wire
is up against the
and not in the
way of the eject
fingers. This could
cause damage to
the wire.
20
Icemaker
Plug
Cover
Wire
OFF
ON
Power Switch
To install water valve, follow the installation instruction
label on the back of the unit above the machine
compartment.
Attention – Water Valve Installation Procedure
1 Disconnect the power from the refrigerator.
2 3
Pull out the water valve Assemble refrigerator
connector in the right side wiring connector to
of machine compartment. water valve.
Remove the cover from
connector.
5 6
Close box and insert Install water valve on
the screw into the pro- refrigerator cabinet
tective box. with screw.
Water Supply to the Icemaker
A GE Appliances water supply kit (containing tubing,
shutoff valve, fittings and instructions) is available at
extra cost from your dealer or by visiting our Website at
GEAppliances.com (in Canada at geappliances.ca) or
from Parts and Accessories, 1.877.959.8688.
icemaker Owner's Manual from the kit.
Icemaker
4
Take connector protec-
tive box out of accessory
bag. Install it over both
refrigerator and water
valve wiring connectors.
For some models, the
box is covered by alumi-
num foil. Do not remove
the aluminum foil from
the box during the instal-
lation.
Reverse above as-
sembly sequence (①
⑥ ⑤ ④ ③ ②) to
remove water valve
from refrigerator cabi-
net.
49-1000592 Rev. 4