Publicité
4.3 Pyrolysis
The oven is equipped with a pyrolyser cleaning system, which destroys food residues at high
temperature. The operation is carried out automatically by means of the programmer. The resulting
fumes are rendered "clean" by passing over a Pyrolyser wich starts as soon as cooking begins. As very
high temperatures are required by the Pyrolyser, the oven door is fitted with a safety lock. The pyrolyser
can be stopped at any time. The door cannot be opened until the safety lock is displayed.
NOTE : If a hob has been fitted above the oven, never use the gas burners or the electric hot-plates while
the Pyrolyser is working, this will prevent the hob from overheating.
TWO PYROLYTIC CYCLE are pre-set:
ECO PYROCLEAN : Cleans a moderately stained oven. Operates for a period of 90 minutes.
SUPER PYROCLEAN : Cleans a heavily stained oven. Operates for a period of 120 minutes.
Never use commercially available cleaning products on a Pyrolytic oven!
Tip : Carrying out Pyrolytic cleaning immediately after cooking allows you to take advantage of residual
heat, thus saving energy.
Before executing a pyrolytic cycle:
•Remove all the accessories from the oven because they are not able to tolerate the high temperatures
used during the pyrolytic cleaning cycle ; in particular removing grids, side racks and the telescopic
guides (refer to the chapter REMOVING GRIDS AND SIDE RACKS) . In ovens with meat probe it is
necessary, before making the cleaning cycle , close the hole with the nut provided.
•Remove any large spillages or stains as it would take too long to destroy them. Also excessively large
amounts of grease could ignite when subject to the very high temperatures of the Pyrolytic cycle.
•Close the oven door.
•Excess spillage must be removed before cleaning.
• Clean the oven door.
• Remove large or coarse food residues from the inside of the oven using a damp sponge. Do not use
detergents.
• Remove all accessories and the sliding rack kit (where present).
• Do not place tea towels.
Using the Pyrolitic cycle:
If a pyrolysis cycle is chosen the display shows "ECO", that lasts 90 minutes, blinking; by the "+" and "-" it
is possible to change in "SUPER" that lasts 120 minutes.
If a pyrolysis is already started it is no more possible to change from " ECO" to "SUPER" and vice versa.
It is not possible to modify a pyrolysis duration but ending time can be modified.
During pyrolysis the buzzer does not sound.
Pyrolysis is not available if separator or side grids or the meat probe are detected, and it is not
programmable via WiFi.
EN 13
Publicité
