Publicité
Welding Fume：
Welding operations can lead to the emission of toxic smoke and harmful metal
dust. The equipment should be installed in covered areas with smoke inhalers.
Operators must wear smoke masks. Welding materials must be cleaned.
Pay Attention to Fire：
1. Check whether sparks cause fires, especially in the vicinity of flammable
materials.
2. Check that the fire extinguisher is not far from the operator.
3. Place the equipment where there are pneumatic devices.
4. Do not weld on a container with flammable and lubricant, even if it is empty.
5. Do not weld in an atmosphere filled with flammable gas or fuel vapor.
Electromagnetic Compatibility:
Near the welding site, check:
● There are no other power cords, control cables, telephone lines, radio or
television reception equipment, watches, mobile phones, magnetic cards,
computers or any other electronic device.
● No active medical devices (pacemakers, acoustic prostheses) were used
around (at least 3 meters).
FCC Information:
● CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment!
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This product may cause harmful interference.
2) This product must accept any interference received, including interference that
may cause undesired operation.
● WARNING: Changes or modifications to this product not expressly approved by
- 4 -
Publicité
