Publicité
General safety rules:
Before removing the body of the product, pull out the wire first.
The operator must be qualified accordingly.
The operation can only be controlled by qualified technicians.
The compressed air power must be cut off and turned off before the maintenance
operation is carried out.
Electrodes, electrode arms and other secondary conductors can reach very high
temperatures and stay high for a long time after stopping the machine. Pay
attention to scald.
Preventive maintenance is necessary on a regular basis.
Power Connection：
1. Check that the device must be connected to the ground coupler and to the
ground.It is in good condition.
2. Check if the workbench is connected to the ground connector.
3. Ensure that the operator does not have any contact, protection or wet clothing
with the metal parts to be welded.
4. Avoid contact with welded parts.
5. Do not spot weld in very wet places or on wet floors.
6. Do not weld with worn cables. Check that the isolation belt does not have a
default cable or that the connection is loose.
7. Please turn off the device before replacing the electrode.
8. Please disconnect the equipment directly before it is controlled or repaired.
Protection of Eyes and Body：
1. During welding, wear leather gloves, welded apron, safety shoes, welding
protective clothing, arc filtering and radiation projective helmet or glasses.The
operator must protect his eyes during rubbing and hammering.
2. Don't wear rings, watches or jewelry. It can cause burns.
3. All protective board must be in good condition and in proper position. In the
absence of eye protection, do not look at the welding arc. Protect the environment
near the product from projection and reflection.
- 3 -
Publicité
