Publicité
FIG. 2
2"
(51 mm)
RJ11 / RJ12 / RJ45 TESTING
The Digital Toner-Pro has an RJ45 Test Port
the ABN clips to transmit the tone. The RJ45 plug works with RJ11, RJ12,
the ABN clips to transmit the tone. The RJ45 plug works with RJ11, RJ12,
the ABN clips to transmit the tone. The RJ45 plug works with RJ11, RJ12,
or RJ45 jacks. The red
the two center conductors of the inserted plug, i.e. pins 2 and 3 for RJ11,
pins 3 and 4 for RJ12, and pins 4 and 5 for RJ45.
Use the Digital Probe-Pro (sold seperately) to locate the toned wires at the far
end of the cable, as described in the TRACING PAIRED WIRES section.
CONTINUITY TEST (ANALOG TONING ONLY)
The Digital Toner-Pro transmits frequencies on non-energized wires only. When
the Digital Toner-Pro is turned on, a continuity test will be performed to determine
if the 2 wires to be traced are in close proximity to each other, without a conductive
path between them. The "CONT" Indicator
pass. Attach the red and black ABN Test Clips
If the resistance of the circuit is less than 10kΩ, the "CONT" Indicator
illuminate red, indicating a short, and no toning can occur. If the "CONT" Indicator
is illuminated green, a tone can be generated and testing can proceed.
OPERATING INSTRUCTIONS
and black
T14 T14
T15 T15
close proximity to
VDV500-223
(sold seperately)
that can be used in place of
that can be used in place of
T21 T21 T21
ABN Test Clip leads
ABN T
wIll illuminate green to indicate
wIll illuminate green to indicate
wIll illuminate green to indicate
wIll illuminate green to indicate
T4 T4
,
to the wires to be tested.
to the wires to be tested.
T14 T14 T14 T14 T14
T15 T15
are replaced by
will
will
T4 T4
7
Publicité
