DeWalt DC901 Mode D'emploi page 29

Charge only with dedicated D
chargers.
See technical data for charging time.
Package contents
The package contains:
1 Cordless midhandle driver/drill
1 Side handle
1 Battery pack (DC901K/DC910K)
2 Battery packs (DC901KL/DC910KL)
1 Charger
1 Kitbox (K-models only)
1 Instruction manual
1 Exploded drawing
NOTE: Battery packs and chargers are not included
with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fi g. A)
WARNING: Never modify the power tool
or any part of it. Damage or personal
injury could result.
INTENDED USE
Your drill/driver has been designed for professional
professional drilling, percussion drilling and
screwdriving applications.
DO NOT use under humid conditions or in presence
of flammable liquids or gases.
These drill/drivers are professional power tools. DO
NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
1 Variable speed switch
2 Forward/reverse slider
3 Keyless chuck/auto spindle lock
4 Torque adjustment collar
5 Mode selector
6 Three-gear selector
7 Bit holder
8 Grip
9 Side handle
10 Battery pack
WALT Charger
E
Your DE9000 charger accepts D
packs of 36 V (DE9360) and 28 V (DE9280) at 2.2 Ah.
10 Battery pack
11 Release button
12 Charger
13 Charging indicators (red)
Auto-spindle lock
The auto-spindle lock is engaged when the
transmission is stationary. The chuck sleeve can
easily be turned with one hand while the other
supports the unit.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualifi ed electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fi t 13 Amperes BS1363A approved plugs
fi tted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable fi rmly and that the two
leads are correctly fi xed at the terminal screws.
E N G L I S H
WALT Li-Ion battery
E
Your D WALT charger is double insulated
E
in accordance with EN 60335.
27