AIRFORCE F121 SLIM 90 IDT Prescriptions De Montage Et Mode D'emploi page 20

GB OPERATION
I DRIVE
3
1
2
ANTI-ODOUR FILTER WARNING ACTIVATION:
If the hood is installed in filtering mode, you must activate the warning that informs when the anti-odour filter is saturated
and should be replaced. Holding the power button down for a few seconds with the hood switched off enables or disables this
function: 4 green flashes of the (F) symbol indicates that it is enabled, while 4 red flashes indicate that it is disabled. Pressing
the power button enables the hood, and the 4 icons will light up blue. These can be activated by
pressing lightly to enter the specific function. The hood will store the last selected settings, namely aspiration power and
lighting.
Pressing this button starts the motor, (at the same aspiration power selected previously), and the relative indicator lights up
green. Slide your finger clockwise or anticlockwise on the circular slider to increase or decrease the aspiration power; The lumi-
nous indicators in sector (1) indicate the aspiration power in the range from 0 to 4. After 5 seconds, if you haven't touched the
slider, the hood will exit from the motor function and the green indicator will return to blue, disabling the adjustment option.
You can switch off the motor and exit from the function by pressing the button a second time, while it is still green. Automatic
operation using the heat sensor: to access this function, press the motor button and slide your finger anticlockwise on the
circular slider until the light on the motor button starts flashing. The temperature sensor will start the motor, choosing the right
aspiration speed. The speed will vary with the temperature coming from the the hob.
Pressing the button will switch on the hob lighting (at the maximum brightness) and the relative indicator will turn green.
After 5 seconds, if you haven't touched the slider, the hood will exit from the lighting function and the green indicator will
return to blue.
Pressing the button again while the indicator is still green switches off the lights and exits from the function.
Pressing this button accesses the hood timer function and the relative indicator lights up green. Slide your finger clockwise or
anticlockwise on the circular slider to increase or decrease the automatic switch-off timer; The luminous indicators in the (3)
sector indicate the set time 5-10-20-40 minutes.. After 5 seconds, if you haven't touched the slider, the hood will exit from the
timer function and the green indicator will return to blue, disabling the adjustment option. Pressing the button again while
the indicator is still green resets the timer and exits from the function.
The hood is equipped with two warnings that indicate when the anti-odour filter and metal filter are saturated (if the function
has been enabled) Pressing the button once, the indicator will light red and you will see the saturation state of the metal filter.
Pressing the button a second time, the indicator lights purple and you will see the saturation state of the anti-odour filter if it
was enabled previously; in this case the luminous indicators in sector (1) show the filter saturation level. When the metal filter
timer reaches 40 hours, the indicator flashes red to show that it is time to wash the metal filter, while it will flash purple after
120 hours to show that the anti-odour filter must be replaced. To reset the warning, enter the filter state visualisation, choose
the one in alarm and then hold the power button down until the indicator turns off.
All hoods with capacities exceeding 650 m3/h have the last speed timed; It lasts for 7 minutes, after which it automatically
returns to the last non-timed speed.
20