Publicité
Instruction CF-RU Repeater Unit
3. Placing and Mounting
The Repeater Unit has been assigned
When the Repeater Unit has been assigned to the Master Controller, discon-
nect it from the temporary 230V power supply outlet
•
Place it somewhere between the Master Controller and the room therm
stat (with the unsatisfactory link test) – see g. 5 – and connect it to a 230V
power supply outlet
•
Verify the transmission to the Master Controller by making a link test from
the Repeater Unit – see 4
•
Perform another link test from the room thermostat with 1) the
unsatisfactory link test or 2) where system enlargement is required
Note: Extending the transmission range of the CF2 system
•
Up to three Repeater Units can be installed in a chain – see g. 5
•
Several chains of Repeater Units can be added to one Master Controller
– see g. 5
8
VI.UH.N1.52
Produced by Danfoss Floor Heating Hydronics 08.2008
Publicité
