Publicité
Instruction CF-RU Repeater Unit
Front Cover – g. 3
Front cover release
Push Button – g. 4
Push button (for installation/transmission test)
2. Installation
Note: The Repeater Unit is installed when system enlargement (transmission distance) is
required, or when other system components cannot reach the Master Controller (link test is
unsatisfactory).
Temporarily connect the Repeater Unit to a 230V power supply outlet no further from the
Master Controller than you can operate both products.
Activate Install mode on Master Controller – g. 4
•
Use the menu selection button
ashes
•
Activate Install mode by pressing OK
6
VI.UH.N1.52
to select the Install mode. Install LED
. Install LED
Produced by Danfoss Floor Heating Hydronics 08.2008
goes ON
Publicité
