Safety Instructions; Initial Operation - Peter Bausch Easy Sonic Mode D'emploi

Please read all available documentation (instruction of use and safety instructions) carefully before using the
product! We assume neither responsibility nor liability for accidents, damages and malfunctions resulting from
inobservance of these guidelines. The instructions have to be stored in a safe place and have to accompany the product
at all times; Especially, if the product gets passed on to a third party!

SAFETY INSTRUCTIONS

• C heck the device every time you use it – do not use the device if it appears to be damaged or faulty. Injury and
electrical shock hazard!
• D evices with the nominal voltage 220/230V, 50Hz are only allowed to be plugged in appropriate isolated ground
receptacles. Device may overheat!
• For operating only use the included mains adapter. Fire hazard!
• D o not bend, crush or squeeze the connecting cable! Connecting cable should never come in contact with hot surfaces!
Risk of electrical shock due to damaged cable insulation!
• C hildren often underestimate the dangers electronic devices can cause. That is why children should never use electronic
devices without direct supervision of an adult! Injury and electrical shock hazard!
• M ains adapter has to be plugged out of the ground receptacles after every use. Fire hazard due to overheating!
• D ANGER! Neither open nor damage the device by forcefully impacts. Injury and electrical shock hazard!
• D o not use the device on children's skin. Their skin is much more sensitive than adult's skin and could be damaged
due to misapplication.
• D o not use if you suffer from open wounds or skin burns.
ATTENTION
• I n case of sensitive skin: Test the device on a less sensitive part (e.g. forearm) to ensure that there are no skin irritations
or blemishes.
• U sing the device for the first time should only be a short time application to find out your skins reaction.
• Facial application should never take longer than 60 seconds.

INITIAL OPERATION

ATTENTION: Before plugging the mains adapter into the ground receptacle, you have to connect the charging cord with
the mains adapter.
1. B efore first time usage or after using the device after a long period of non-operation make sure to fully charge the device.
Connect the tail end of the charging cable (J) to the connection point (I) at the mains adapter. Plug the mains adapter
into the ground receptacle and place the hand turned off piece (A) in the charging station (I). The control light provides
information about the charging status: the lamp is blinking during the charging process, a constant light indicates that
the device is charged completely. You are able to use the EasySonic for 40 minutes if the battery is fully charged.
Regularly charge the device for 6h.
2. C hoose the desired attachment (B, C or D).
Hint: Never use the device if you suffer from irritated or sore skin.
3. Make sure that the cleaning brush is attached to the driving axle (E) tightly.
4. Wet the cleaning brush (the device is waterproof) and your skin. Before, remove makeup with a cleaning cloth.
5. C hoose the cleaning product and apply it to the device. The EasySonic can be used with almost any type of cleaning
product whether it is a lotion, gel or only water.
6. Switch on the device (F) and choose the desired speed setting (G).