Publicité
CONNECTIONS FOR PERFORMANCE CHECKS
NOTES:
1. REGULATION AND RIPPLE METERS MUST NOT BE GROUNDED THROUGH THREE-WIRE LINE CORD TO GROUND.
2. PERFORM CHECKS WITH LOCAL SENSING CONNECTIONS ONLY.
SAFETY INSTRUCTIONS - NNS15:
1. FUSES MUST BE CHANGED BY AUTHORIZED SERVICE PERSONNEL ONLY!
F1: T2.0A
250V
F2: 15A
250V
(NNS15-5).
8A
250V
(NNS15-12, NNS15-15).
5A
250V
(NNS15-24).
2. POWER SUPPLY MUST BE SECURED TO THE CHASSIS OF THE END USE EQUIPMENT BY 4 SCREWS INSERTED INTO THREADED
OPENINGS IN THE BOTTOM OF THE POWER SUPPL Y ENCLOSURE (REFER TO OUTLINE DRWG.).
3. MAXIMUM LEAKAGE CURRENT OF END-USE EQUIPMENT SHOULD NOT EXCEED 3.5mA.
CE MARK
CE Marking when applied to a product covered by this handbook indicates compliance with the Low Voltage Directive (LVD) of the
European Union in that it complies with EN 60950-1.
A "Declaration of Conformity" in accordance with the preceding directive and standard has been made and is on file at our EU
representative TDK LAMBDA UK, located at Kingsley Avenue, Ilfracombe, Devon EX34 8ES, UK.
The latest revision of EU Declaration of Conformity is available via company web site www.uk.tdk-lambda.com/technical-data
3
Publicité
