Publicité
FOR CUSTOMER SERVICE CALL: 800-750-2723 EXT 5050
ASSEMBLE THE SURROUND
j
g
c
q
e
SURROUND ASSEMBLY
VIEW FROM BACK
1.
Lay pieces face down on carpet or other soft surface
to protect finish during assembly. The Surround
consists of two side panels, a top panel, and a
decorative trim frame.
2. Bolt the top panel (a) to the side panels (b & q) so
the top surfaces are flush to one another using items
c and d.
3. Assemble the trim frame. The trim consists of a left
(f) and right (e) side piece and a split top piece (left
h, right g). These are joined by corner connectors
(m,n,&p) and two straight center connectors (j&k).
These slide into the channel on the back of the frame
and are secured with two set screws (p) in each piece.
4. The trim slides over the surround assembly and
is secured at the base of each side with a machine
screw.
5. The Surround Assembly is then slid over the
appliance. Slots in the two side panels accommodate
the hood at the top of the appliance. The surround
assembly is held in place with two springs at the top
of either corner of the appliance.
Figure 6. Surround Installation
SPRING
© 2021 United States Stove Company
All manuals and user guides at all-guides.com
m
n
p
h
k
a
f
b
d
SURROUND
Slots in surround
slide of rebox top
ASSEMBLY INSTRUCTIONS
6. Connect power cord of blower to grounded receptacle.
7. Firebrick extends the life of your stove and radiates
heat more evenly. If firebricks were removed to
position appliance, replace them before firing
appliance. See figure 7 for proper orientation and
positioning. Install the back row first, then sides and
finally install bottom firebricks.
FIREBRICK INSTALLATION
CAUTION: RISK OF FIRE!
• REPLACE
FIREBRICKS
WOODSTOVE. POSITION FIREBRICKS SO NO
GAPS REMAIN BETWEEN BRICKS.
• NEVER OPERATE THIS APPLIANCE WITH
MISSING OR CRACKED FIREBRICK.
• KEEP FURNISHINGS AND OTHER COMBUSTIBLE
MATERIALS AWAY FROM THE STOVE AND
OUTSIDE MINIMUM CLEARANCES.
A
A
B
B
B
A
F
C
BLOWER INSTALLATION
Remove blower assembly from packaging and check for
any damage. Notify your dealer if any damages exist.
Securely mount the blower to the heater with the two (2)
screws and washers provided.
4
BEFORE
A
A
A
B
B
A
D
A
A
B
G
C
E
FIRING
Publicité
