Kobalt SGY-AIR230 Mode D'emploi page 12

OPERATING INSTRUCTIONS
1. To tighten or secure the threaded
fasteners/workpiece, turn the
forward/reverse knob (C) counterclockwise
to the forward position. Press the
trigger (D). The tool anvil (B) runs
clockwise, tightening/securing the threaded
fasteners/workpiece (See Figure 1).
2. To remove or loosen the threaded
fasteners/workpiece, turn the
forward/reverse knob (C) clockwise to the
reverse position. Press the trigger (D). The
tool anvil (B) runs counterclockwise
removing/loosening the threaded
fasteners/workpiece (See Figure 2).
1
B
2
B
12
Counterclockwise
C
Clockwise
C