ENGLISH
G) Setting of work and pause times
Programming procedures
The access to programming is given by the key P3. There are 4 different ways to enter upon programming:
Press P3 for 3 sec. and wait for the Led DL1 switch on with steady light, to program work times of the wings.
Press P3 for 3 sec., Led DL1 issues a short flash, then press again P3 once before the Led DL1 switch on with steady light, to program pause time.
Press P3 for 3 sec., Led DL1 issues a short flash, then press again P3 twice before the Led DL1 switch on with steady light, to program the delay in
opening of motor M1.
Press P3 for 3 sec., Led DL1 issues a short flash, then press again P3 three times before the Led DL1 switch on with steady light, to program the
delay in closing of motor M2.
Note: After the first press of the P3 key for 3 sec. (programming start), the subsequent key presses must be carried out after each flash of
the Led DL1 (max. 3).
Programming of work times for wings
The programming of times for the leaf 1 is performed using P1
The programming of times for the leaf 2 is performed using P2
Program the times for the leaf 2 by means P3 when you wish that the leaf 1 works with the same times (only one programming for both leaves).
Procedure of programming for a gate with two different opening angles
Adjust RV1 trimmer clockwise up to the end of stroke and place the leaf M1 up to full closing and the leaf M2 up to full opening,
Press the key P3 for 3 sec. to enter in programming mode. Led DL1 issues a short flash and then it lights up with a steady light,
Without hesitation, press the key P1 for 1 sec., after a short time, M1 leaf opens at slow down speed up to the end of stroke (full opening),
Once reached the stroke end (full opening), M1 leaf closes at nominal speed up to the end of stroke (full closing),
Once reached the stroke end (full closing), M1 leaf stops. Working time of leaf M1 has been programmed.
Place the leaf M2 up to full closing,
Press the key P3 for 3 sec. to enter in programming mode. Led DL1 issues a short flash and then it lights up with a steady light,
Without hesitation, press the key P2 for 1 sec., after a short time, M2 leaf opens at slow down speed up to the end of stroke (full opening),
Once reached the stroke end (full opening), M2 leaf closes at nominal speed up to the end of stroke (full closing),
Once reached the stroke end (full closing), M2 leaf stops. Working time of leaf M2 has been programmed. End of procedure.
24