Publicité
Step 3.Check for flame at the burner. If burner does not light immediately turn control knob to 'OFF'
position and try again from the start. Allow 30 seconds between ignition attempts for gas to dissipate.
Several attempts may be necessary.
Failure to follow this lighting procedure may result in flame roll out beyond the emitter grid.
Step 4. With the burner alight keep control knob depressed for 15 seconds.
Step 5. For minimum heat turn the control knob to 'LOW'.
Step 6. To turn heater off, turn the control knob to 'OFF'.
Storage
Always close the gas valve of the gas cylinder after use or in case of a disturbance.
Remove the pressure controller and the hose.
Check the tightness of the gas valve and for damage. If you suspect damage, have it changed by
your gas dealer.
Never store liquid gas cylinder in a sub-terrain, or at places without adequate air ventilation.
Cleaning And Care
Wipe off powder coated surfaces with soft, moist rag. Do not clean heater with cleaners that are
combustible or corrosive.
Remove debris from the burner to keep it clean and safe for use.
Cover the burner unit with the optional protective cover when the heater is not in use.
Trouble Shooting
Problem
Main burner won't light
Note: If the appliance cannot be adjusted to perform correctly it should not be used until serviced or
repaired.
Warning: Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Any modifications or adjustments made to product without prior authority from the
manufacturer will void any warranty claims.
Possible Causes
• No gas
• Low gas pressure
• Blockage in orifice
• Manual valve not in 'LOW' or 'HIGH'
Position
• Exposure to rain
Solution
• Replace cylinder
• Replace cylinder
• Remove blockage
• Position to high
• Remove emitter and clear
burner pores
Publicité
