Publicité
Important Safety Rules:
This appliance must only be used in a well-ventilated area.
1. This appliance shall not be installed or used indoors, in buildings, garages or other enclosed area.
This outdoor heater is not intended to be installed on recreational vehicles and/or boats.
2. DO NOT place articles on or against this appliance.
3. DO NOT use or store flammable materials near this appliance.
4. Children and adults should be alerted to the hazards of high surface temperatures, burns and
clothing ignition.
5. Children should be carefully supervised when they are in the area of the appliance.
6. NEVER hang anything including clothes or other flammable items on or near the appliance. Direct
contact with metal surfaces should be avoided in order to prevent burns or clothing ignition.
7. DO NOT operate this appliance unless it is fully assembled with reflector in place.
8. DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
9. Installation and repair should be done by a qualified service person. The appliance must be
inspected before use and at least annually by a qualified service person. More frequent cleaning may
be required as necessary. It is imperative that control compartment, burners and circulating air
passages of the heater be kept clean.
10. The hose assembly should be properly located out of pathways where people may trip over it. The
hose must be protected from contact with hot or sharp surfaces both during use and while in storage.
The hose assembly should be visually inspected prior to each use of the heater. If excessive abrasion
or wear is evident, or the hose is cut, it must be replaced prior to operating the heater. The
replacement hose assembly may be obtained from the manufacturer.
11. DO NOT use any pressure regulator or hose assembly other than those supplied with the
appliance. Replacement pressure regulator and hose assembly must be those specified. Replacement
parts may be obtained from the manufacturer or your local sales representative.
12. Installation and use of this heater must conform with local codes or, in the absence of local codes,
with the Standards of Storage and Handling of Liquefied Petroleum Gases.
13. This heater is designed to operate with a standard 10Kg gas cylinder with Approved Cylinder
Connection. A dented, rusted or damaged cylinder may be hazardous and should be checked by your
cylinder supplier. Never use a cylinder with a damaged valve connection. The cylinder must be
arranged to provide for vapor withdrawal. Never connect an unregulated cylinder to the heater.
14. The valve outlet must be maintained in good condition. When the cylinder is not in use, be sure to
cover it with a dust cap. A leak test should be performed with soapy water whenever connecting a new
cylinder. NEVER use a match to test for leaks.
15. The cylinder must be turned off whenever the heater is not in use. When the heater is to be stored
indoors, the cylinder and the heater must be disconnected and the cylinder stored in accordance with
the Standard for Storage and Handling of Liquefied Petroleum Gases.
16. The area heater has been designed with several safety features which include a tip over switch.
Screw the coupling nut of regulator into the cylinder valve outlet. (Cylinder not included)
Publicité
