Publicité
SAFETY FEATURES
TIP-OVER PROTECTION
Your heater is equipped with a Tip-Over Safety Switch. When your heater tips over, it will
turn off automatically.
OVERHEAT PROTECTON
Your heater is equipped with an Overheat Protection System. When the threshold
temperature has been reached, your heater will turn off automatically.
*To reset your heater after the Overheat Protection System has been activated:
1.
Turn the Power Control Switch to the 'O' position and turn the Temperature Control
Switch to the lowest setting.
2.
Disconnect the power cord from the electrical outlet. Allow your heater to cool down
for approximately ten minutes.
3.
Ensure that both the intake and the exhaust vents are clear of obstructions.
4.
Connect the power cord to the electrical outlet.
5.
Turn the Power Control Switch to the 'II' position and turn the Temperature Control
Switch to the highest setting.
6.
If your heater does not operate normally, turn the Power Control Switch to the '0' position,
disconnect the power cord from the electrical outlet, and consult an authorized repair
technician.
TROUBLESHOOTING: Review this manual to ensure that you understand the basic operations
and features of your heater.
1.
Check your household circuit breaker or fuse.
2.
Check for obstructions at the intake and exhaust vents.
•
If obstructions are present, refer to the instructions for resetting your heater when
the Overheat Protection System has been activated.
•
If no obstructions are present, and your heater still does not operate normally, turn
the Power Control Switch to the '0' position, disconnect the power cord from the
electrical outlet, and consult an authorized repair technician.
6
Publicité
