Publicité
GB
Note: Always empty the dust container in
due time, such that the best possible dust
absorption is maintained.
Mounting the router compass
► P. 6, fig. 7
– Remove the parallel stop (15).
– Push the router compass (18) onto one of the two
guide rods (14) and tighten its clamping bolt.
– Insert the guide rod with the compass into the
router as illustrated.
– Adjust the milling radius by moving the guide
rod (14). For this, measure the distance between
the tip of the compass and the outer and/or inner
edge of the milling cutter.
– Tighten the clamping screws (5).
Mounting the copy ring
► P. 6, fig. 8
Note: Always choose a milling cutter
diameter that is smaller than the interior
diameter of the copy ring.
– If mounted, dismantle the extraction adapter.
– Screw on the copy ring (19) from below using
countersunk head screws (17) and hexagon nuts.
The copy ring (19) can and should be mounted
together with the extraction adapter (16).
Operation
Check before starting!
DANGER! Risk of injury! The product
must only be put into operation if no
defects are found. Ensure that any defec-
tive parts are replaced before the product
is used again.
WARNING! Risk of injury (cuts from
sharp edges)! Never work in the direction
of your own body. Keep your hands away
from the immediate work area.
Check the safe condition of the product:
– Check whether there are any visible defects.
– Check whether all parts of the product are firmly
attached.
WARNING! Risk of rebound! Always
guide the milling cutter, never the work-
piece!
Always hold the product firmly in both
hands.
Never pull the milling cutter backwards!
Never tilt the milling cutter!
The base plate must be positioned safely
and if possible with the full surface on the
workpiece.
34
WARNING! Risk of injury! Never hold
the workpiece to be processed in your
hand, on your lap or against any other
parts of your body.
Always clamp in the workpiece firmly.
Do not process any workpieces which are
too small to clamp tightly.
WARNING! Risk of injury (cuts from
sharp edges)! Never work in the direction
of your own body. Keep your hands away
from the immediate work area.
NOTICE! Risk of product damage! Only
use milling cutters suitable for the material
to be processed.
Always guide the milling cutter with only
moderate effort.
Pre-select the speed
NOTICE! Risk of product damage! The
motor can overheat if continuously run
under heavy load and at low speeds. If the
motor has been run at elevated speed,
allow it to cool by idling.
The required speed can be pre-selected using the
rotary regulator for the working speed (12), or can
also be changed during operation.
• 1–2 low speed
• 3–4 moderate speed
• 5–6 high speed
The following tables show standard speeds for orien-
tation purposes. The suitable speed depends on the
material and can be established by trying out, if nec-
essary.
Hard wood (e. g. beech)
ø milling cutter
4–10 mm
12–20 mm
22–40 mm
Soft wood (e. g. pine)
ø milling cutter
4–10 mm
12–20 mm
22–40 mm
Chipboard
ø milling cutter
4–10 mm
12–20 mm
22–40 mm
Plastic
ø milling cutter
4–15 mm
12–20 mm
Setting the milling depth
DANGER! Risk of injury! Only adjust the
milling depth when the device is switched
off.
Speedlevel
5–6
3–4
1–2
Speedlevel
5–6
3–6
1–3
Speedlevel
3–6
2–4
1–3
Speedlevel
2–3
1–2
Publicité
