Publicité
Wear hearing protection when working with
the product.
Wear a dust mask when working in a dusty
environment.
Do not wear protective gloves when work-
ing with the product.
Wear tight-fitting clothing when working with
the product.
Cover long hair or wear a hair net if neces-
sary.
Your product at a glance
Note: The actual appearance of your
product may differ from the illustrations.
► P. 3, fig. 1
1. Setting screw for depth stop
2. Clamping screw for depth stop
3. Depth stop
4. Variable stop
5. Clamp screws for guide rods
6. Spindle locking
► P. 4, fig. 2
7. Safety lock
8. On-Off switch
9. Tool holder
10. Cutter
11. Base plate
12. Rotary regulator for working speed
13. Clamping lever for milling depth
Scope of delivery
• Instructions for use
• Router
• Assembly wrench
• Parallel stop with guide rods
• Cross-head screws
• Adapter for dust extraction
• collects (2×)
• central pin
• template guide
Using for the first time
DANGER! Risk of injury! Before all work
on the product, disconnect the mains plug.
Clamping the workpiece
► P. 4, fig. 3
CAUTION! Risk of injury! Special tools,
which ensure that the milling blades are
sharpened at the right angle and the right
depth, and that the cutters run without
vibration at high speeds, are required for
sharpening milling cutters. Have the mill-
ing cutter sharpened by a professional!
Worn or improperly sharpened milling cut-
ters can cause rebounds. Most severe
injuries may be the result!
CAUTION! Risk of burns! The tool may
still be hot on completion of the work. Allow
a hot tool to cool down. Never clean a hot
tool with flammable liquids.
CAUTION! Risk of injury (cuts from
sharp edges)! There is a danger of cut-
ting even with a stationary tool! Wear
gloves when changing the tool.
WARNING! Risk of injury! Only use
undamaged and clean milling cutters.
Only use milling cutters with a suitable
shaft diameter and milling cutter diameter.
Remove the extraction adapter (► P. 5,
fig. 5) if the milling cutter exceeds this
diameter
– Keep the spindle lock (6) pressed.
– Using the assembly wrench, loosen the nut from
the tool holder by turning in anti-clockwise direc-
tion.
– Push the milling cutter (10) 20 mm into the tool
holder (9) until a spring-loaded resistance is
noticeable.
– Tighten the union nut of the tool holder in clock-
wise direction.
– Release the spindle lock (6).
Mounting and setting the parallel stop
► P. 5, fig. 4
– Push the guide rails (14) against the parallel stop
and tighten using the cross-head screws, as illus-
trated.
– Push the parallel stop (15) into the holder on the
device as illustrated.
– Set the parallel stop (15) to the required measure-
ment and screw in the guide rod respectively with
the clamping screw (5).
Connect the dust extraction unit
WARNING! Risk of injury! Use a special
extractor to remove particularly hazard-
ous, carcinogenic substances or dry dusts.
► P. 5, fig. 5
– Place the adapter for dust extraction (16) onto the
device as illustrated.
► P. 6, fig. 6
– Screw down the adapter from below using
screws (17).
– Push the suction tube of a suitable vacuum
cleaner onto the adapter for dust extraction.
GB
33
Publicité
