Publicité
GB
ment parts will not only lead to an invalida-
tion of the warranty, they may also endan-
ger you and your environment.
Device-specific safety instructions
• When the product has been turned off,
always secure it to prevent accidental
switching on.
• Do not use devices if the On-Off switch is
not in proper working order.
• Keep the handles dry and free from
grease.
• Keep the work area clean and tidy when
working with the product.
• Make sure there is adequate lighting
when working with the product.
• Always hold the device firmly with both
hands.
• Keep supply lines and limbs away from
the tool.
• Make sure you are standing firmly and
that you have a natural posture when
working. This enables you to react better
to usual or unexpected reactions of the
device caused by backlash, blockage,
jamming, tool breakage or workpiece
breakthrough.
• Only use fault-free accessories suitable
and approved for the device. Incorrectly
fastened, damaged or worn tools can
cause intensive vibrations, by means of
which the device may become uncontrol-
lable. Loosening or breaking tools or
splinters thereof can cause injuries.
• The device is not suitable for operation in
potentially explosive atmospheres.
Sparks may occur during work, which may
ignite flammable liquids, gases, chippings
or dusts.
• Never reach into moving parts when the
device is in operation.
• Use as counterbearing or a support han-
dle, depending on the work situation.
Work carefully so as not to trap limbs
between the workpiece and the counter-
bearing e.g. in confined working condi-
tions.
• The On-Off switch must be released upon
breakdown of the power supply, to pre-
vent sudden startup upon reactivation of
the power supply.
• Do not operate the device in idling mode
in order to prevent the tool from being
flung away.
22
• Please observe the specified tightening
torque for screwed connections and use a
torque gauge to check. Insufficiently tight-
ened screws may loosen in time and
cause accidents.
• Do not operate the device if other persons
without protective clothing are within
reach.
• Symbols appearing on your product may
not be removed or covered. Signs on the
product that are no longer legible must be
replaced immediately.
Read and observe the instructions
for use before using the product for
the first time.
Wear hearing protection.
Wear protective goggles.
Wear a dust mask.
Wear tightly fitting clothing.
Your product at a glance
Note: The actual appearance of your
device may differ from the illustra-
tions.
► P. 3, fig. 1
1. Tool mount
2. Switcher for rotational direction
3. On-Off switch
4. Setting screw for torque
5. Hose connection
6. Oil filling screw
7. Air outlet
Supplied as standard
• Instructions for use
• Impact wrench
• Sockets 9–27 mm (10×)
• Plug-in coupling
Operation
Check before switching on!
Check the safe condition of the product:
• Check whether there are any visible
defects.
Publicité
