Publicité
8. Fully tighten the strap bolts, ensuring that the mounting brackets do not move when doing so. Taping the brackets in place
can help prevent any movement.
9. Double check the measurements from Step 7 to ensure the brackets are still positioned correctly.
10. While the air cleaner is removed, drill a 1 1/8" hole in the plastic panel that sits behind the air cleaner as shown in Figure 9.
This will be used to bring the wiring harness into the engine bay.
11. Reinstall the air cleaner.
12. Remove the air cleaner lid and screen.
13. Install the rear light bar onto the rear mounting bracket with the supplied 10-32x1/2" truss head screws and external tooth
washers. Ensure the wiring harness is routed through the mirror arm cutout on the light bar, below the mounting tabs on the
bracket, and behind the mirror arm cover. Push the light bar firmly against the air cleaner when tightening the fasteners.
14. Install the front light bar onto the front mounting bracket with the supplied 10-32x1/2" truss head screws and external tooth
washers. Ensure the wiring harness is routed through the cutout at the top of the inner side flange on the panel. Push the
light bar firmly against the air cleaner when tightening the fasteners.
15. It is recommended to open/close the hood at this point to ensure there is no interference between the front light bar and the
hood. If necessary, remove the front light bar and adjust the position of the front mounting bracket to gain more clearance
between the light bar and the hood.
16. Route the wiring harness through the hole drilled in Step 10 and into the engine bay. Tuck the harness outside the engine bay
between the air cleaner and the plastic panel behind it, as shown in Figure 10.
Page 5 of 18
Figure 9: Where to Drill for Wiring Harness to be Run (Driver Side Shown)
00813117
08/2024
Publicité
