Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTALLATION INSTRUCTIONS:
1. Remove the light by prying it off at the areas where the slots are located (top and bottom of the light). Note: The lights are held
with two tinnerman clips.
2. Unplug the light from harness.
3. Clean the area on the truck that the 3M tape will be applied to, using the supplied an alcohol swab.
4. Peel a 1" section of the red tape from each section of tape on the backside of the door contour accent. Place and secure it to the
face of the door contour. This will aid in peeling the remaining tape, once the door contour accent is set in place.
5. Once the tape has been peeled, the light can be placed back to its original place by connecting the wiring harness, aligning clips
on the back of the light with holes in the outer skin, and pressing the light into door to engage clips.
Page 1 of 3
CAB DOOR CONTOUR ACCENTS
Peterbilt 567 & 579
Figure 1
IIPB049
Follow steps 3, 4 & 5
08/2015
Publicité
Sommaire des Matières pour Dieter's Panelite Peterbilt 567
- Page 1 CAB DOOR CONTOUR ACCENTS Peterbilt 567 & 579 INSTALLATION INSTRUCTIONS: 1. Remove the light by prying it off at the areas where the slots are located (top and bottom of the light). Note: The lights are held with two tinnerman clips. 2.
- Page 2 GARNITURE DE CONTOUR DE PORTE DE CABINE Peterbilt 567 & 579 INSTRUCTIONS D’INSTALLATION: 1. Retirez la lumière en faisant levier là où les fentes sont situées (en haut et en bas de la lumière). Remarque : Les lumières sont maintenues avec deux clips tinnerman. 2.
- Page 3 ACENTO PARA CONTORNO DE PUERTA DE CABINA Peterbilt 567 & 579 INSTRUCCIONES DE INSTALACIÓN 1. Quitar la luz haciendo palanca en las áreas donde se localizan las ranuras (arriba y abajo de la luz). Nota: las luces están sujetadas con dos clips tinnerman. 2.