Publicité
Operation
Display
1.
Eco/Auto mode
2.
Timer
3.
Temperature/timer display
4.
Heating level (1-3)
Controls
a.
Temperature
b.
Temperature & Timer +1
c.
Mode selection
d.
Timer
e.
Temperature & Timer -1
f.
Stand-by
Symbols on the remote
a.
Temperature
b.
Temperature & Timer +1
c.
Mode selection
d.
Timer
e.
Temperature & Timer -1
f.
Stand-by
3
1
4
2
a
b
d
e
c
f
d
a
b
e
24
Switch on
Switch on
1.
Switch the On/Off switch on the side of the housing to the "I" position to
switch on the device. A signal tone can be heard. The standby key (
and the timer key (
2.
Press the standby key (
the different modes. Each entry is confirmed with a signal tone.
Temperature
c
Setting range of the desired temperature: 5 °C - 35 °C, setting of the frost
protection: 5°C
f
1. Press the power/mode key (c) to set the mode. The modes change
through one after the other. Selection with the +/- keys is not
possible.
2. Use the "+" and "-" keys [b] and [e] to set the operating time of the heater
between 1 and 24 hours. This radio press the thermostat key (a), the
temperature display flashes.
3. Use the "+" and "-" keys [b] and [e] to set the desired temperature.
4. The temperature display stops flashing and the set temperature appears
on the screen.
Note
Regardless of the mode in which you set the temperature, the heater will
operate only in ECO mode after the thermostat is set.
Note
The temperature displayed on the screen is only the set temperature.
) light up.
) to exit the standby mode and start selecting
25
)
Publicité
