Publicité
Product
1. Power switch
2. Radiator fins
3. Display
4. Controls
5. Handle
6. Cable jam
7. Wheels
4
Caution
The handle is intended only for pulling and moving the standing radiator.
It must not be used for carrying the device with one hand. Before carrying
the radiator you should always wait until it has cooled down! For carrying,
we recommend to hold the radiator with one hand on the handle and the
other hand on the opposite round end of the heating tube.
5
3
2
1
6
7
22
Assembly
Turn the radiator over on a scratch-free and stable surface to avoid damaging
the paintwork or the floor covering (see Fig. 1).
Insert the rear wheel base into the fixed U-bracket and screw the two wing
nuts tightly onto the bolt (see Fig. 2 - 3).
Note
If the wheel carrier cannot be pushed down completely, turn it and
otherwise try a little force. No gap should remain between the wheel
carrier and the radiator.
Fasten the front wheel base to the underside of the front panel with the two
screws (see Fig. 4).
Attach the front wheel carrier to the underside of the front panel with the two
screws without hole in the center by screwing the screws into the E-inserts.
(see Fig. 4).
WARNING
Operate the radiator only in normal, upright position with the wheels on
the bottom (wheels down, controls up), any other position may result in a
hazardous situation.
23
Publicité
