Publicité
All manuals and user guides at all-guides.com
Installation
5. To assign a password, press and hold the "*"
6. Once the custom password is entered, the orange
7. After your password is successfully confirmed, the
8. If the SATA drive has not been formatted, you will
9. Your enclosure is now ready to read and write data.
16-11-238-933690.indb 5
button for 5 seconds or until the orange LED
illuminates. Enter your 4 to 6-digit custom
password, then hit the "#" button to enter.
LED will shut off, though the password must be
reentered for confirmation. If your password is
successfully confirmed, the green and blue LEDs
will illuminate. If your password confirmation
is unsuccessful, the red and green LEDs will
illuminate to indicate the passwords do not match.
host computer will immediately identify the hard
drive connected to the keypad.
first need to format it using your computer's Disk
Management Utility in order to copy and access
files.
The green LED will blink to indicate data is being
transferred.
5
12/20/2016 4:20:37 PM
Publicité
