Publicité
All manuals and user guides at all-guides.com
Installation
Notes:
• Once the password is set and data is encrypted, losing
the password or hardware failure will result in lost data.
Removing the drive and placing it in another enclosure will
not allow access to the data. It is recommended that all data
stored on the enclosure be backed up to another location
regularly to prevent data loss.
• HDD/SSD drives are sensitive to static electricity and must be
handled properly to avoid the risk of data loss. Always handle
your HDD/SSD drive with caution by wearing an anti-static
strap (such as Tripp Lite P999-000) or touching a grounded
metal surface to discharge yourself of static electricity prior to
picking up the drive.
1. Slide off the enclosure cover to reveal the drive
2. Slide a 2.5" SATA drive into the drive tray. Align the
3. Slide the enclosure cover back on the unit. Flip the
4. Press and hold the "1" and "3" buttons on the
16-11-238-933690.indb 4
tray.
SATA plug on the drive to the SATA connector in
the drive tray.
unit over so its keypad faces upward.
keypad for 20 seconds. At the same time, connect
the included USB cable between the USB port on
the unit and a USB port on the host computer. The
green LED will blink for a moment, then the red
and green LEDs will illuminate solid to indicate the
unit is ready to be assigned a password.
4
12/20/2016 4:20:37 PM
Publicité
