Publicité
Safety Information
For your safety, read all instructions carefully before operating the appliance.
Before Using Your Appliance
►
Remove all exterior and interior packing.
►
Before connecting the appliance to the power source, let it
stand upright for approximately 2 hours. This will reduce the
possibility of a malfunction in the cooling system caused by
handling during transportation.
►
Clean the interior surface with warm water using a soft cloth.
►
The door on this appliance can be opened from either the
left or the right side. The unit is delivered with the door
opening on the left side. Should you wish to open the door
from the right, follow the instructions, "Reversing the Door
Swing of your Appliance," listed below.
Installation of Your Appliance
WARNING
Do not store or install the appliance outdoors.
►
The appliances are designed for either built-in, or free-
standing installation.
►
Place your appliance on a floor that is strong enough to
support it when it is fully loaded. To level your appliance,
adjust the 4 legs until level.
►
Locate the appliance away from direct sunlight and sources
of heat (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly.
►
Never place the unit in damp areas.
►
Plug the appliance into an exclusive, easily accessible
electrical socket.
►
Any questions concerning power and/or electrical connection
should be directed towards a qualified electrician or an
authorized products service center.
►
The air vent at the front of the appliance must never be
covered or blocked in any way.
WARNING
Keep clear of obstruction all ventilation openings in the
appliance enclosure or in the structure for building-in.
6
►
The appliance must be installed to all electrical connections
in accordance with state and local codes.
►
Use two or more people to move and install the cooler. Failure
to do so can result in back or other injury.
►
The cooler may experience decreased cooling efficiency if air
flow is restricted due to a fully loaded cabinet.
►
Install the cooler in a well-ventilated area where the ambient
temperature is above 50ºF and below 90ºF.
Attention
►
Never overload the cabinet.
►
Never open the door unless necessary.
►
Never cover shelves with aluminum foil or any other shelf
material which may prevent air circulation.
►
Do not store explosive substances such as aerosol cans with
a flammable propellant in this appliance.
►
Should the appliance be left empty for long periods, it is
suggested that the appliance be unplugged, and, after
careful cleaning, leave the door ajar to allow air to circulate
inside the cabinet in order to avoid possible condensation,
mold or odors from forming.
Save These Instructions
If you are experiencing problems, check the Troubleshooting
Guide at the back of this manual. It lists causes of minor
operating problems that you can correct yourself.
PRPW24C02CG Use, Care, and Installation Guide
P R E S R V ™
W I N E C O O L E R
D U A L Z O N E
Publicité
