Publicité
NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back
and fully tighten all bolts. This will make the assembly easier.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Securely screw 12 Cam Bolts (2) into the designated small holes on the Top Panel (A) and Side Panels
(B and C), Tighten the cam bolts with a Phillips screwdriver.
NOTE: Screw-in cam bolts must be screwed down flush. DO NOT over tighten the cam bolts.
3. Glue 4 Wood Dowels (3) into the inner holes on the Side Panels (B and C).
NOTE: It is very important to use a small amount of glue on both ends of dowels and wipe away the
excess glue immediately with a damp cloth.
Assembly Instructions
2
A
B
3
C
B
3
7
C
3
3
Publicité
