Publicité
27. To insert the assembled Sliding Tray (P) into the lower frame. Extend the Ball Bearing Slide Tracks on
the panels all the way forward (including ball bearing cart). Then align the Slide Runners on the tray with
the Slide Tracks and push the tray carefully inside until it stops.
NOTE: If the sliding tray does not go in smoothly, please take it out and repeat the step. If you need to
remove the file holder, please pull the tray all the way out, then simultaneously pushes the plastic release
lever of the ball bearing slides up on one side and down on the other side, and then pull it completely out.
13
S
28. Extend the Door Hinges (S) and rest two hinge cups onto the cutouts of each Door Panel (M and N).
Secure the Door Hinges (S) in place by using two 15 mm Screws (13) in each.
Assembly Instructions
B
M
C
P
13
S
16
Ball bearing cart
FRONT
FRONT
Ball bearing cart
N
Publicité
