Publicité
19. Insert two 15 mm Bolts (4) with Washers (6 and 7) through the metal tabs of Middle Back Stretcher (Q)
and screw into both Side Frames (D and E).
20. Now, go back and securely tighten all the Cam Locks and Screws. Make sure that all the parts are tight
and there are no gaps between the parts. This will help keep the unit square.
21. Unfold the Back Panel (O) and align the pre-drilled holes against the upper edge with the pilot holes on
the back of Top Back Stretcher (I). and attach it in place with the 15 mm Washer Head Screws (8)
provided.
NOTE: We recommend attaching back panel with washer head screws at the corners
Assembly Instructions
Q
E
O
O
14
D/E
Q
7
6
4
D
8
The adhesive tapes
face outward.
first.
Publicité
