Publicité
The product stops when the pressure on the switch is released.
Before removing the accessory, wait for the blades to stop completely, then unplug the power cord plug from the socket and
remove the accessory from the drive housing.
It is recommended not to use the product for more than 2 minutes of continuous operation. Next, wait for the product to cool down
completely.
Do not use the product for frozen food products.
Ice cubes can only be crushed in a glass cup. The ice cubes must not be larger than 2 cm in any size and a small amount of water
must be added to the cup before crushing begins.
The mill is designed for grinding products such as coff ee or pepper, etc. Do not grind seeds, bones, shells, ligneous parts of plants.
Pour not more than 30 g of products intended for grinding into the mill container. Do not grind for more than 1 minute of continuous
operation. Next, wait at least 15 minutes for the product to cool down. Do not use the cutting attachment as a mill and do not use
the mill as a cutting attachment. The mill may only be used with the mill container and should not be used with other accessories.
CAUTION! If the device begins to vibrate after switching it on, if it makes an unusual sound, or shows any other signs of malfunc-
tion, switch it off immediately, unplug it, and check for the cause of the malfunction.
Product maintenance
CAUTION! Before cleaning, switch the product off , unplug the power cord from the wall socket, wait for the unit to cool down, and
then proceed with maintenance.
CAUTION! It is recommended to clean the components of the product after operation. This will prevent food residues from drying
up and make cleaning the product easier.
If the drive housing is contaminated with processed food during operation, stop your work, unplug the product by removing the
plug from the socket, clean the product, and only then resume operation.
Use only mild kitchen cleaning agents to clean the product. It is not allowed to use abrasive cleaning agents, e.g. cleaning powder
or milk, or agents containing corrosive substances. Do not use any solvents, petrol, or alcohol to clean the product.
Dilute the cleaning agent with water, according to the instructions supplied with the agent. Then, apply it on a soft cloth and clean
the drive housing on the outside.
Remove any residues of the cleaning agent with a soft cloth slightly soaked in clean water. Then, dry all surfaces with a dry soft cloth.
CAUTION! The drive housing is not designed for water jet cleaning. Do not immerse the drive housing in water or other liquid.
Before fi rst use, wash the inside of the accessories and the cutting attachment under a running lukewarm water with detergent,
then rinse with clean water and dry with a cloth or allow to dry.
The cup must be cleaned from the outside as in a manner specifi ed for cleaning the drive housing.
No part of the product is suitable for cleaning in dishwashers or under high-pressure water jets.
All the components must be thoroughly dried, before reusing the product.
Avoid contact with the human body, when cleaning the blades. Wash with brushes or sponges.
Bottle lids and the cutting base are equipped with seals (V). The seals must be removed for cleaning. The seals should be carefully
lifted with a blunt plastic or wooden tool. Do not use metal or sharp tools to lift the seals to prevent damage to them. A defective
seal will not ensure tightness and must be replaced with a new, damage-free one.
Transport and storage
Before commencing storage or transport of the product, clean it thoroughly from food residues.
If stored, keep the product indoors, and make sure it is not exposed to dust, dirt, or moisture. It is recommended to store the
product in its original packaging.
TECHNICAL DATA
Parameter
Catalogue No.
Rated voltage
Rated frequency
Rated power
Protection class
Weight
O R I G I N A L
12
EN
Units
[V a.c.]
[Hz]
[W]
[kg]
I N S T R U C T I O N S
Value
67703
220-240
50 / 60
500
II
0.9
Publicité
