Publicité
Forward
Speed
Back
2.4G Remoter Control Instructions
If a code is required for the first use, note that this product features a memory function.
When replacing the battery in the future, you do not need to match the code again. To
code:
① Hold the 'M' button for over three seconds until the first LED starts flashing.
② Power on the device; a continuously lit LED indicates successful coding.
③ The remote control will automatically enter standby after 10 seconds of inactivity;
press any key to reactivate.
④ Key Description: "▲" Move forward, "▼ " Move backward,"◄" Turn left, " ►" Turn
Right, "S" Speed control, "P" Brake.
To adjust the speed, press 'S':
● One light: Low speed
● Two lights: Medium speed
● Three lights: High Speed (note: The car only moves at medium speed when
reversing).
To apply the brakes, press 'P':
● The indicator will flash fully
● Press 'P' again to release the brake
How to insert batteries:
Using the screwdriver, loosen the screw on the back of the remote control, then open
the battery cover. Following the diagram, insert two AAA 1.5V alkaline batteries, then
close the cover and tighten it with the screw and screwdriver.
How to remove batteries:
Using a screwdriver, loosen the screw on the back of
the remote control, open the battery cover and remove
the batteries. Then, close the cover and tighten it with
the screw.
Note:
Following steps ① and ②, synchronise the remote control with the car before initial
use. The remote control possesses a memory function, allowing it to automatically
sync with the car when batteries are changed.
Ensure proper polarity (+ and -) when inserting batteries. When batteries are depleted,
they must be replaced.
Remote control instructions
Speed indicator
10
Stop
Right
Left
Code
Publicité
