Publicité
EN - ADJUSTABLE BENCH TOP ROLLER STAND
Dear Customer,
Thank you for purchasing this Trend product, which should give lasting performance if used in
accordance with these instructions.
TECHNICAL DATA
Body size
Roller size
Height adjustment
Maximum load
Weight
The following symbols are used throughout this manual.
Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance
of the instructions.
Refer to the instruction manual of your power tool.
This unit must not be put into service until it has been established that the power tool to be connected
to this unit is in compliance with 2006/42/EC (identified by the CE marking on the power tool) or UK
Statutory Instruments 2008 No. 1597 – The Supply of Machinery (Safety) Regulation (identified by
UKCA marking on the power tool).
INTENDED USE
This adjustable roller is intended for use with mitre saws mounted on a bench or other flat surface to
support lengths of material.
SAFETY
Please read and understand the safety points in these instructions as well as you power tool instructions.
PLEASE KEEP THESE INSTRUCTIONS IN A SAFE PLACE
Keep fingers away from the roller and raising mechanism.
Please do not modify the product.
Ensure stand is on a flat surface.
Safety Points
1.
Disconnect power tool attachment from power supply when not in use, before servicing, when
making adjustments and when changing accessories such as cutters. Ensure switch is in "off"
position and cutter has stopped rotating.
2.
Read and understand instructions supplied with power tool, attachment and cutter.
3.
Current Personal Protective Equipment (PPE) for eye, ear and respiratory protection must be
worn. Keep hands, hair and clothes clear of the cutter.
4.
Before each use check cutter is sharp and free from damage. Do not use if cutter is dull, broken
or cracked or if any damage is noticeable or suspected. Only use tools for woodworking to
EN847 safety standard. Ensure cutting tool is suitable for application.
5.
The maximum speed (nmax) marked on tool or in instructions or on packaging shall not be
exceeded. Where stated, the speed range should be adhered to.
260mm x 130mm
25mm diameter x 250mm
50mm to 160mm
62kg
2kg
EN - R/STAND/A
-4-
Publicité
