Publicité
CLEANING AND MAINTENANCE
Before cleaning, you must disconnect and pull
out of the power supply!
Cleaning the hair clipper under the running
water. Then use a soft cloth to wipe dry for
product and the blade. For better storage
suggest to add a few drop lubricating of oil to
the blade.
After water washing,If it's not for immediate
use, please place the product at a certain angle
for several hours,the water inside the machine
can flow out.
• Cleaning the clipper blades regularly will
maintain their optimal performance.
• Important maintanence is the squeeze a few
drops of oil onto the blades. The enclosed oil is
specially formulated for clippers.
• Blades must be realign if they have been removed for cleaning or
replacement
• To realign the blades,simply match the upper and bottom
blades teeth up, point for point.(End of top blade teeth should be
approximately 0.5-1.0mm back from bottom blade.Compare your
clipper blades with the sketch)
If blade alignment is incorrect,add a few drops of oil to the blade,turn
clipper on for a few moments,turn off and unplug.Loosen screws
slightly and adjust. Tighten screws after blade is aligned.
Cutter Maintenance
To maintain your clipper in peak condition,the blades should be oiled
every few haircuts.
-To oil it properly,the unit should be held so the blades are in a
downward position.With the clipper blade running,dispense 2-3 drops
of oil across the top blade.
AHC-5050 Instruction Manual
5
Publicité
