Publicité
USE
Changing the comb attachments
1. Release the protect cap on its bottom end,pull it off.
2. To install the comb attachments and push the corresponding comb attachment onto the
hair clipper carefully .
3. Press the bottom end of the comb attachment firmly until it lock into place.
4. If you would like to remove the comb attachment, release it on its bottom end.
5. Pull the comb attachment off of the hair clipper.
Cutting hair
1. Select one of the appropriate comb accessories for the comb fitting from (1.5mm /3mm
/4.5mm /6mm /10mm /13mm).
2. Comb your hair thoroughly and smoothly.
3. Wrap the cloth or robe around your throat and neck to prevent the shock from falling into
your collar.
4. Begin the haircut with the hair clipper attachment from the neck or the sides and trim
towards the middle of the head. Then cut the front part of the hair towards the middle of the
head.
5. Hold the hair clipper and make the comb attachment work flat on the head. Then run it
evenly through your hair.
6. If possible, trim the hair against the direction of its growth.
7. To ensure that you trim all hairs, please run the hair clipper over the same area several times
for cutting hair .
8. If the comb attachment is not be installed, it only can be used to trim very short hair.
9. Comb your hair thoroughly and smoothly again and again.
Blade assembly
Sketch shows how the bottom blade holes are larger than the shanks of
the blades screws. When the blade screws are loosened the bottom blade
can be aligned with tight after the blade is aligned.
Cutting contours and beards
1. To cut the hair very short or a beard or contours, use the product
without the comb attachment.
2. Use the slide control for the fine adjustment. Adjust the cutter by
rotating the adjusting ring from forward to downward.When the lever is
in the uppermost position, the blades will give the shortest cut.Pushing
the lever downward gradually increases the cutting length.
3. Shorten or cut the hair as desired.
1. End of the top blade teeth should be 1/32"to
5/64,0.79mm to 1.98mm back from bottom blade. This is
important so that the clipper doesn't cut too close or allow
the moving cutter to touch the skin.
2. Extreme left hand tooth of top blade must be covering
or be to the left of the first small tooth of bottom blade.
3. Extreme right hand tooth of top blade must be touching
the big tooth on the bottom blade.
4
Publicité
