Publicité
1.
Remove control panel from packing
foam. (See Figure 1)
Figure 1
2.
Attach control panel. Feed excess
cable into the control panel head.
Align three holes in control panel with
three holes on pallet truck base.
(See Figure 2)
Figure 2
3.
Remove the two screws (one on
each side) to release the front panel.
Carefully open the front panel.
(See Figure 3)
Figure 3
6 OF 59
ASSEMBLY
4.
Align mounting holes on pallet truck with
mounting holes on control panel.
(See Figure 4)
Figure 4
5.
Insert and tighten 3 hex screws (H109)
with spring washers (H110) through
base of control panel with hex wrench
provided. (See Figure 5)
Figure 5
Hex Screw
Hex Screw
(H109)
(H109)
Washer
Washer
(H110)
(H110)
6. Close front panel and secure with
2 screws. (See Figure 6)
Figure 6
1024 IH-11553
Publicité
