Publicité
Install the Kickplates
Install the kickplates
C
F1
A. Front of cabinet
B. Front kickplate
C. Side kickplate
F1. Hex bolt
1� Position the front & side kickplates to the corner brackets and
align kickplate end holes with the holes in corner brackets.
2� Insert the four hex bolts (F1) through kickplate end holes into
corner brackets.
NOTE: The side kickplates will be on top of the front kickplate
flanges.
3� Return the cabinet to its upright position. Unlock door.
Install the Hanging Rod
Install the hanging rod
A
A. Hanging rod
The cabinet has pre-installed closet rails on the side panels which
are suitable for a hanging rod.
1� Unlock and open the cabinet doors.
2� Place the hanging rod into the closet rail openings and slide
down and into position.
Remove/Replace/Adjust the shelves
C
A
B
A. Slot
B. Shelf tab
1� Remove the shelf clips from their shipping position on the
sides of the cabinet. Working from the inside of the cabinet
and using a blunt tool, push out the white plastic shelf clips.
2� Discard the clips.
3� Lift up on the underside of the shelf until the shelf tabs are free
of the cabinet slots.
4� Tilt the shelf up to reposition it within the cabinet or to remove
it from the cabinet.
NOTE: Plan your shelf heights and install shelves starting from
the bottom. The shelves are supported by the metal tabs on
side walls of the cabinet.
5� Determine the placement of the shelves.
6� Tilt the shelf so that one end is higher than the other.
7� Insert the shelf into the cabinet so that the higher end is
directly above the desired slots and push the shelf down in
place behind the side slots.
8� Raise the lower end so it is directly above the desired slots
and push the shelf down.
NOTE: A shelf must be located in the center position for the
cabinet lock to function correctly. Make sure the shelf tabs are
in place behind all the slots, as shown.
9� Repeat this process for the remaining shelves.
1� Place the cabinet in the desired location.
2� Level the cabinet by adjusting the leveling legs.
The cabinets are designed with adjustable doors.
1� Check to see whether the doors need adjusting. It is more
often the left door that will need to be aligned.
2� Using a Phillips screwdriver, loosen all screws attaching the
hinge to the cabinet.
3� Adjust door to the desired height.
4� Tighten the screws.
Adjust Shelves
Level the Cabinet
Adjust Doors
A
B
5
Publicité
