Publicité
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed:
10 mm Wrench
■
Parts for Cabinet:
Corner bracket (4)
■
Front kickplate (1)
■
Side kickplate (2)
■
Hanging Rod (1)
■
Cabinet Use Requirements
Intended for use in a garage.
■
Maximum weight limit is 300 lbs (136 kg) for each shelf, not to
■
exceed 1500 lbs (680 kg) for the cabinet.
Hanging rod not to exceed 50 lbs (23 kg).
■
Unpack the Cabinet
1� Remove keys from door handle.
2� Open the cabinet door.
3� Remove and verify the contents. See "Parts for Cabinet" for
your model.
4� Dispose or recycle all packaging materials.
NOTE: Keep the outer carton layer. It is needed to cushion the
cabinet during leveling leg and corner bracket assembly.
4
PARTS SUPPLIED
F1
Callouts
Description
F1
M6 x 16 mm hex bolts
F2
Leveling Legs
ASSEMBLY INSTRUCTIONS
Full-width shelves (4)
■
Leveling leg (4)
■
Key (2)
■
M6 x 16 mm hex bolt (20)
■
F2
Quantity
20
4
Install the Leveling Legs and Corner
Brackets
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
Install the leveling legs and corner brackets
A
C
F1
F2
A. Front of cabinet
F1. Hex bolt
C. Corner bracket
F2. Leveling leg
1� Close and lock the cabinet doors.
2� Using two or more people, place the cabinet on its back using
the outer carton layer to cushion the cabinet.
3� Insert 4 hex bolts (F1) through each corner bracket and into
the cabinet and then tighten with wrench.
4� Install the leveling legs (F2) to the corner brackets.
NOTE: If you need to open the cabinet doors during
installation of leveling legs and corner bracket assembly, open
them slowly and do not put any weight on the open doors.
This avoids damage to the hinges.
Publicité
