Publicité
-
With two lights, the battery has a capacity of approx. 25% -50%
-
With one light, the battery has a capacity of approx. 0% - 25%
The appliance is equipped with a battery protection system. This system automatically interrupts the power
supply to the motor to extend the service life of the battery. The appliance switches off automatically during
operation if the appliance and/or the battery are placed in one of the following conditions:
Overload:
The tool is being operated in such a way that it is drawing an unusually high current. In this case, switch off
the device and end the application that caused the device to be overloaded.
Then switch the device on to restart it. If the device does not start, the battery has overheated.
In this case, allow the battery to cool down before switching the device back on.
Low battery voltage:
The remaining battery capacity is too low and the appliance is not working. When you switch the device on,
the motor starts running again but soon stops. In this case, remove the battery and recharge it.
Pressure gauge (pressure measuring device)
If the object to be inflated is connected to the tool, the air pressure of the object is displayed on
the pressure gauge when you switch on the device. If nothing is connected to the tool,
the pressure gauge displays "0".
You can set the air pressure on the pressure gauge. To change the unit, press the unit button.
To increase the pressure, press the plus button. To decrease the pressure value, press the minus button.
You can set the pressure value between 0 kPa and 1034 kPa (150 PSI).
Original manual FX-E1CI20_rev02
25
Publicité
