Publicité
Step 21
å
Carefully stand your unit upright.
å
Slide one SHELF MOLDING (F) onto the notched edge of one
of the ADJUSTABLE SHELVES (D).
å
NOTE: The MOLDING should be centered on the SHELF.
å
Repeat this step for the remaining SHELF MOLDINGS (F) and
ADJUSTABLE SHELVES (D and O).
å
Push a RUBBER SLEEVE (2R) over one end of each METAL
PIN (1R). Insert the METAL PINS into the hole locations of
your choice in the ENDS (A and B) and UPRIGHTS (J). Set the
ADJUSTABLE SHELVES (D and O) onto the METAL PINS.
B
O
J
1R
(16 used)
2R
Page 26
Notched edge
Slide the MOLDING (F)
onto the notched edge.
D
J
D
These surfaces should be even.
D
F
J
O
A
434912
Almost time to
celebrate! With a nap.
The groove
is closer to
this edge.
www.sauder.com/service
Publicité
